Tổng quan về Huawei Switches Series S5730-48C-SI-AC
S5730-48C-SI-AC is a Huawei S5730-48C-SI Bundle, providing 24 x Ethernet 10/100/1,000 ports, 8 x 10 Gig SFP+, with 1 interface slot, and 150W AC power supply. Huawei S5730-SI series switches are next-generation standard gigabit Layer 3 Ethernet switches that provide flexible full gigabit access and cost-effective fixed GE ports and 10 GE uplink ports, meanwhile can provide 40 GE uplink ports with an interface card.
The S5730-SI was developed based on next-generation high-performing hardware and the Huawei Versatile Routing Platform (VRP). The S5730-SI supports simplified Operations and Maintenance (O&M), intelligent Stack (iStack), flexible Ethernet networking. It also provides enhanced Layer 3 features and mature IPv6 features. The S5730-SI can be used as an access or aggregation switch on a campus network or as an access switch in a data center.
Thông số kỹ thuật Huawei Switches Series S5730-48C-SI-AC
S5730-48C-SI-AC Specification
Ports
24 x Ethernet 10/100/1,000 ports;
8 x 10 Gig SFP+
Slots
One extended slot that supports an interface card: 4 x 40 GE QSFP+ interface card
Power Supply
Dual pluggable AC or DC power supplies, one 150W AC power supply equipped by default
Forwarding performance
240 Mpps
Switching capacity
680 Gbit/s
Memory (RAM)
1 GB
Flash
512 MB in total. To view the available flash memory size, run the display version command.
Mean time between failures (MTBF)
47.83 years
Mean time to repair (MTTR)
2 hours
Availability
> 0.99999
Service port surge protection
Common mode: ±7 kV
Power supply surge protection
Using AC power modules: ±6 kV in differential mode, ±6 kV in common mode
Using DC power modules: ±1 kV in differential mode, ±2 kV in common mode
Dimensions (W x D x H)
442.0 mm x 420.0 mm x 44.4 mm (17.4 in. x 16.5 in. x 1.75 in.)
Stack ports
Any 10GE SFP+ or 40GE QSFP+ ports
Ports on the 2-port QSFP+ rear stack card
RTC
Supported
RPS
Not supported
PoE
Not supported
Rated voltage range
100 V AC to 240 V AC, 50/60 Hz
-48 V DC to -60 V DC
Maximum voltage range
90 V AC to 264 V AC, 47 Hz to 63 Hz
-36 V DC to -72 V DC
Maximum power consumption (100% throughput, full speed of fans)
62.4 W (without card)
Typical power consumption (30% of traffic load)
Tested according to ATIS standard
EEE enabled
No PoE power consumption
39.02 W (without card)
Operating temperature
0°C to 45°C (32°F to 113°F) at an altitude of 0-1800 m (0-5906 ft.)
NOTE:
When the altitude is 1800-5000 m (5906-16404 ft.), the highest operating temperature reduces by 1°C (1.8°F) every time the altitude increases by 220 m (722 ft.).
The operating temperature of the switch is 0°C to 40°C (32°F to 104°F) when it uses QSFP+ optical modules with 10 km or longer transmission distances.
Short-term operating temperature
-5°C to +50°C (23°F to 122°F) at an altitude of 0-1800 m (0-5906 ft.)
NOTE:
When the altitude is 1800-5000 m (5906-16404 ft.), the highest operating temperature reduces by 1°C (1.8°F) every time the altitude increases by 220 m (722 ft.).
The equipment can operate beyond the normal operating temperature range for a short-term period, but the following conditions must be met:
The equipment operates at a temperature of over 45°C (113°F) consecutively for at most 96 hours in one year.
The equipment operates at a temperature of over 45°C (113°F) for a total of no more than 360 hours in one year.
The equipment operates at a temperature of over 45°C (113°F) for no more in 15 times in one year.
The equipment may be damaged or experience unexpected exceptions if any of the preceding limits is exceeded.
The equipment cannot start when the temperature is lower than 0°C (32°F). The maximum distance of optical modules used in these conditions cannot exceed 10 km.
Storage temperature
-40°C to +70°C (-40°F to +158°F)
Noise under normal temperature (27°C, sound power)
< 59.4 dB(A)
Relative humidity
5% to 95%, noncondensing
Operating altitude
AC power modules configured: 0-5000 m (0-16404 ft.)
DC power modules configured: 0-2000 m (0-6562 ft.)
Certification
EMC certification
Safety certification
Manufacturing certification
_____Uy tín – Chất lượng_____
CÔNG TY TNHH THƯƠNG MẠI DỊCH VỤ NÉT VIỆT PRO
Địa chỉ: : 447/23 Bình Trị Đông, khu phố 5, phường Bình Trị Đông A, quận Bình Tân, Tp. Hồ Chí Minh